For those of you who still haven't received the update or want to flash it manually, head on to read the step-by-step guide to update your Samsung Galaxy S2 Plus to the latest XXUBMG8 official firmware update.
Note: this tutorial is specifically written for Samsung Galaxy S2 Plus model IP, which is the international variant. Do not attempt this on any other devices or variants. Required files: download the firmware file from here. Was the update completely flashed on the phone? If it were, the phone would have rebooted into the new OS. Connect the phone to the computer and run ODIN again. Make sure the com port is lit up, which will indicate that the phone is connected correctly, and the drivers are installed.
You'll need to put the phone in download mode when connected to the computer. To do so, press and hold the "Power" and "Volume Down" buttons at the same time. Make sure this time, the file is fully flashed, and you see the pass sign:. See more questions like this: I need download file for update jelly bean 4. In the step: "From the recovery screen, choose 'install zip from SD card' and then choose the.
If you don't have the "Install Zip From SD card" option on your system recovery, this just means that you are not using a custom recovery.
Please install CWM on your phone first before proceeding with the update. To install CWM on your phone, do the following. See this image [3]. Intermittent signal issue. Replaced SIM card but still have the same issue. On jellybean 4. The Samsung Galaxy S2 has a lot of issues, not only with the device itself but with the software on the device.
Contact your mobile carrier so they can help diagnose the problem remotely to your device. There are several ways for you to try to resolve this issue. Try the suggestions below and see if any of them solve the issue. It may be that your power button has gotten stuck, which would be why you are experiencing this problem during the reboot sequence. Try fiddling with that and see if it is stuck, and if so, try to get it unstuck.
If that does not resolve your issue, turn off the phone and take the battery out, then insert it back in. If it is still stuck in the boot loop, your phone likely needs to have a general cleaning. You'll need to take all the parts apart to clean in this case, specifically, the power button , and remove any dirt or grime lurking in your phone.
Before taking the phone apart, try to press and hold the power button only for about a minute with extra effort, then after one minute shake the phone. It may sound ridiculous, but it might resolve the problem. It's also possible that a battery issue is keeping your phone stuck in a boot loop or stuck on the Samsung Logo. What you need to do is check to see if the battery is working okay.
If you have another battery that is the same as the one in your phone, try swapping it and checking to see if you have the same issue. If you have the same issue, you need to take your battery out of the phone - you can use a pick or toothpick or an emery board Nail File. To fix a potential battery cleanliness issue, look for the three little bronze terminals in the place where you place your battery in your phone and clean them.
Next, gently scrape the three terminals on the battery, then re-insert it into the battery dock. Damien is a UK-based video producer for 9to5Google.
Find him on Twitter: iamdamienwilde. Email: damien 9to5mac. January 5. Home Tech Hardware Samsung Galaxy. Was this step helpful? Yes No I need help. This will open up the Galaxy Gear control panel. Scroll down to settings and you will tap one time on settings. After tapping on 'Settings', you will scroll down to the 'About Gear' option shown under 'System'. You will see that the Gear will be updating software, as indicated on your smart phone.
When done, tap 'OK' to proceed. Once the Galaxy Gear restarts, you will see an update progress bar or progress meter showing you that the Gear is updating software.
0コメント